×
If you use an XURON DTF powder shaker, you may encounter some typical issues that are difficult to use. If the powder isn’t coming out as a uniform spray, one issue that could occur is … This may occur when the shaker is clogged or if the powder is lumpy. Another possibility is that powder isn’t spreading evenly on the transfer film, and it’s affecting what your prints look like.
If you’re struggling with your DTF powder shaker, here are a few things to try to fix it. First, check that there isn’t a clump of powder inside the shaker. Shake the shaker gently to free the powder. You may even want to try adjusting the settings on the shaker to help take care of the powder spreading. If the issue persists, try cleaning the shaker to clear any obstructions.
Blockages are pretty common with the DTF powder shakers, but there’s a simple fix. How to clean your XURON DTF powder shaker - Remove the powder bottle and examine the nozzle for clogs. Use a small brush or a pin to remove any powder that’s clogging the nozzle. Step 8 Once the clog is gone, reassemble the shaker, and shake it to make sure the powder spreads evenly.
There are a few things you can try to get the most out of your XURON DTF powder shaker! To start, don't forget to shake the shaker vigorously to before every use to prevent clogging. Verify the settings of the shaker, as this might need some adjustment to evenly sprinkle the powder. (It’s just a smart move to use a good powder that plays well with your shaker for optimal results.)
INVENTORY TECHNICALLETTER To Correct Inadequate Pull Browning Model 1885 Weak Ejection of Spent Cartridge Cases 520000172 Broken Firing Pin - All Locked-Breech Firearms Discoloration to M3A1 Flashlights 91005947A Revolvers Models 9422 and 9417 not Extracting Correctly Models 1885 and 1885 Winder Musket Firing Pin Blowout Hunting/Target Rifle Models 1885 High Wall, 1885 Low Wall, 1885 Winder Musket Re.
If your powder is not adhering correctly with the XURON DTF powder shaker, then try this. First, make sure the tension of the sifting part is adjusted correctly -- that the powder flows out appropriately. You might also experiment with adjusting the shaker speed to find out what works for you. If problem still exists, the sifting part may need to be replaced or contact XURON customer service for assistance.
